![]() Improperly bled remotes don't have enough fluid in them, so the damper has more compression damping in both settings (locked and unlocked) than would be desired. The damper itself is quite nice when the remote is bled properly, which isn't necessarily the case from the factory. However, I don't have any shifters so I can put the (righthand) Xloc on the left side under the bar like a left shifter. I'm a singlespeeder, and I really like the XX damper with Xloc. Then all you have to do is screw the new damper in! Make sure you use the correct weight of suspension oil. Might be worth just changing all your oil at this point. Check oil volumes from SRAM for your new damper and add/remove oil as necessary. Then pull it out of the upper tube and let remaining oil drip off back into the tube. Alternatively, you can use a big adjustable wrench and leave the banjo on and just spin it around. Pull off the banjo and then use a 24 mm socket to unscrew the damper. Use a very small flat screwdriver to pry the end up and then follow it around until it's fully removed. You just have to remove the banjo by removing the very thin helical retaining ring (like a thin keyring) that holds the banjo on. If you have to swap out the damper, you can probably do this yourself as its pretty simple. This is more expensive though as you'll have this extra damper sitting around. Or, you can just buy the compression damper itself from a SRAM dealer and swap it out. Of course, you can buy a new SID with the RCT3 damper instead of the XX damper. If you don't want to use the Xloc remote, you'll have to buy another damper such as the RCT3 damper, which uses a crown mounted adjuster. So basically, you need the remote attached and bled properly to use the fork. If you remove the remote, or if it loses fluid (such as in a crash when the hose gets ripped off), the piston is fully extended and the damper has maximum low speed compression damping and significant high speed compression damping (the damper has a springy blowoff system). An internal spring pushes the piston out. When the piston is pushed in, the compression damper is "off", when the piston is pushed out, the compression damper is "on/damping". Requires at least a minimum amount of power to function.The Xloc is hydraulic: it simply pushes a piston inside the compression damper, like a hydraulic brake. Demolishing refunds the building materials, they are dropped on the ground.Ī light that illuminates the surrounding area. If the structure is reserved for a squad the members of that squad can also use the demolish option. However it can only be done if it's fully repaired, there are no enemy nearby, and it was built less than 7 days ago. The original builder of a pole can instantly demolish it using the button in its menu. If enough players flag it for disruptive placement, then the Friendly Fire immunity is removed and can be destroyed. However one can be flagged for "Disruptive Structure Placement" using a button at the bottom of its menu. ![]() ![]() Power Poles are not very sturdy and can be damaged by 12.7mm machine guns. The reservation lasts 52 hours but it can be refreshed at any moment by the original builder or their squad mates. The original builder of a pole can reserve it for its active squad or a particular squad in the pole's menu so that only the original builder and the players in that squad can upgrade it or disconnect the power lines.
0 Comments
Leave a Reply. |